1. Standard gear pumps can be mounted from Group 1 and Group 2, as well as multiple gear pumps, both right and left. The pumps are installed inside the oil tank, immersed in oil, allowing a reduction in overall dimensions, quieter operation and longer component life.

2. Oil suction filter - It is also possible to mount a return filter, inspectable from the outside, with or without by-pass.

3. The foot mounting support allows putting the C.P.I. in the most suitable position, either horizontal or vertical.

4. There is the widest possible selection of motors: alternating current electrical motors with standard B5 flanging (up to 5,5 Kw), direct current motors and diesel or gasoline internal combustion engines.

5. Oil plug with air hole in visible position.

6. Pressure - gauge: can be positioned at a variety of points of the power pack, to make it as easy as possible to see.

7. The C.P.I. can be equipped with a single or double-acting manual pump, even applicable to multiple duty cycles through manual distributors. This is very useful in certain situations in the event of a power failure (such as for construction equipment).

8. Possibility of mounting standard oil tanks of different capacities from 4 to 36 litres. They can be supplied painted or galvanized for more humid environments. Special oil tanks can also be made upon request.

9. Oil drain plug in position easy to accesse.

10. Oil level gauge in a position of maximum visibility.

11. The C.P.I. features an infinite variety of solutions for motion control needs depending on the customer's specific requirements. It is possible to mount a variety of different types of modular blocks with connections in parallel or in series, for relief valves, Cetop 3 or Cetop 5 valves, solenoid valves and cartridge type valves, pressure switches, pressure reducing valves, manual distributors, flow dividers, heat exchangers, hydraulic accumulators, level switches etc.